They key is not completely in the socket but I ...
They key is not completely in the socket but I think it would fit well after I dupe the original key.
Dont buy this cheap item!
This was junk! Do not buy! The metal is cheap that my key cutter could not copy & it broke.
Missing one screw for the package
received the package but only see one screw , is missing one screw on one of the key package
Excellent replacement fit for my original key shell
Perfect fit for replacing the outer shell of my Prius key. Easier to open and put in the electronic circuit board than the original key (which is glued shut). Would buy again if needed.
Good Fit; Lighter grade plastics
I bought two and both arrived together--- ontime. Product was as advertised. They are shells with no innards. Replacement took old electronics & chip without incident and any less or more size tolerances. One of my replacements is an SKS special FOB; I use a rubber cover on it so the new plastic shell is well-protected anyhow. Plastic does feel a bit inferior in plastic construction than the OEM, but only time will tell how well they hold up.
it works like new.
It was exactly as advertised. Replacing the case for my Prius key was certainly hugely easier and cheaper than replacing the remote. And, with the new case and a new battery, it works like new.
It was easy to replace the fob and it works perfectly. The uncut key is a bit too long for the case but the original cut key fits perfectly.
I have only used the product for one week, however I am very satisfied. It was a challenge removing the 'old' electronics but thanks to some youtube videos, the process was made easier. I am not using the 'new' key so I am not able to comment on the key product.
Great if you have a relative who's a locksmith!
Great price! The problem with this item was getting some one to actually cut the key. Ended up shelling out just as much money to the locksmith to get it cut as a replacement from Lexus.
The Prius key fob shell to get.
I already went through the effort to replace my Prius key fob shell with a far lower quality shell I bought from another site and this was my second internal component swap shell. This key fob is far higher quality and was much easier to install the components with. Even my remote opening switch works again! I am buying a second one because I can tell this HelloAuto key fob will last. Great item at a fair price.
Replaced my 4Runner fob with this and couldn't be happier. Just removed the buttons and sensors and swapped ...
Replaced my 4Runner fob with this and couldn't be happier. Just removed the buttons and sensors and swapped over to this much better looking and easier to handle key.
Perfect Replacement case and key for an excellent price!
Perfect Replacement for my broken Lexus Keys and perfect fit for the 2005 Lexus ES 330 key. I simply took it to a good locksmith it cost $40 per key to cut it but it was laser cut to Perfection worth the money!! swapped out the clicker guts that open and close no problem .Broken cases are on the left in the picture, replaced ones are on the right. My locksmith said he would charge me $58 per case not including the key cutting. I got two for $9.99!!
fits great and has not fallen out
Replaced my factory key fob that broke where the keychain goes. Its affordable, but it also feels a bit cheap imo, also there are silver circles on the back of the buttons one was defective, so I just used my old rubber push pad and it works. I also pealed off my old ford logo and put it in the blank space, fits great and has not fallen out.
Worked perfectly! It took less than five minutes to ...
Worked perfectly! It took less than five minutes to move the circuit board from the old one to the new shell.
i meant to buy the replacement chip but ended up buying this which was the shell. It still worked out perfectly,
It works fine as a wireless Fob but does not work at ...
Wish I had known! This Fob arrived with absolutely NO directions. I did although swap over the electronics with a lot of guessing and get it to work sort of. It works fine as a wireless Fob but does not work at all when you put the Fob in the Fob receptacle in the car. I was told by Toyota this is a known problem that the Fob is not identified in the receptacle as being valid. I believe different years of Prius' have different shapes kind of a cheap version of a unique key. Problem is that attendants at car washes and restaurants usually put the fob in the receptacle which will not start the car - big problem. Putting tape over the receptacle will prevent but is pretty odd! Oh well it does work - sort of! It does look a lot better than the old broken one.
This was exactly what I was looking for. I am glad I bought this item as it had new battery cover screws included. Many of the YouTube videos on replacing the fob case showed that screws did not come with the new case and the old screws would not work.
Works good and saves money.
It did a good job of replacing my broken key fob case. It would be great if it could have some instructions on how to switch the cases. However, I found enough good guidance on the internet to get the job done. Compared to the over $100 that the dealer wanted to replace my key fob, this was a great solution and worth the time to get the cases switched.
The dealership wanted over $ 200 plus dollars for the whole key fob and cpu....I'm glad I found just the fob great deal fits perfect.
I like it overall and it gets the job done
I like it overall and it gets the job done, but it's not perfect. The key does not slide into the slot flawlessly like my original fob does. The key won't go in all the way. I miss the logo on the back too. ALSO, I wish this little package came with a battery so I could get everything in one fell swoop. There are other options on amazon and I think i would try a different fob package next time. However, it does function as said. Comes with screws which is good.
Fits perfectly for 2004 Lexus RX330. Called around Queens ...
Fits perfectly for 2004 Lexus RX330. Called around Queens NY, finally found a place to cut both for $45. That is a saving of $60 each compare to the dealer.
Works like a charm
Works like a charm. It was a little challenging finding someone to cut the key. The dealership wouldn't do it and the hardware store didn't have a laser cutter. You just have to find a real lock smith and they charged $25. I saved about 50% by buying this product.
Works Like a Charm!
Couldn't be easier. Popped out the old innards, put them inside the new one, and tah dah, works like a charm...and I saved a large bundle of cash in the process. Highly recommend.
Great replacement for
This was a perfect replacement for my 2007 Prius fob key cover. Two of the buttons fell out of my old fob so I was looking for a replacement before moisture entered the electronics and fouled up the key. Please note, you have to be very careful when you separate the old cover so that you do not harm the circuit board or the "sensor" at the front end of the key. Once you have the parts installed in the new fob the two fob cover pieces easily snap together. I installed a new battery and everything works like new!
I have had nothing but problems with these keys. ...
I have had nothing but problems with these keys. The ill fitting cases make the buttons stick and the screw hole does not align properly either!!!! I have spent 150.00 having these two keys cut and have nothing but problems. I have had to file the openings to allow the buttons to work freely.This is the first product i am absolutely discussed with !!!! It was not worth purchasing this inferior product. I should have bought OEM.
Very happy with this product
Very happy with this product. Took my electronics out of old into the new fob and used my old key and old silver logo back cover. All worked perfectly. Quick delivery. Thank you
Great value for money
It was very easy to transfer the internals from my old key and to even use the plate with the Toyota logo. Now I have a brand new key.
The price was great, and easy to assemble with parts from the ...
Product was exactly as advertised and exactly what I needed. The price was great, and easy to assemble with parts from the old fob. I would highly recommend this product.
This is the Fob case replacement you're looking for
So it's just a shell which is why I'm attaching pics. It's as one would expect but I 'only' gave 4 star because of a couple things. I would definitely buy it again if I had the choice, there's no doubt, but a couple improvements could easily be made. YOU GET WHAT YOU PAY FOR - I'm confident all my gripes could be resolved by adding $2 which I would eagerly pay 1. It doesn't particularly matter but it's noticeably lighter and my silver border thing sticks out a little. I don't know if I have a faulty case or it's a tolerance issue with the plastics. 2. Was it me or was my battery clip impossible to remove and put in the new one? Can you please add the metal clip thing? 3. They aren't the same so unless you just need the rubber part the front/back of one won't fit the other. Also my old key fits in the new one but the latch won't lock it in. It's fine but pretty sure a tiny modification could fix it
Saved me $230! Just Be Careful When Disassembling Old Key Fob
Awesome! Like many have said, the hardest part is disassembling the old shell, but there are plenty of YouTube videos to guide you! Thank you so much! Saved me $230
Works except the valet key blade is the wrong type
Blade for the valet key is the wrong type and the dealer won't cut it and the original doesn't lock in as the notch that locks it in its slightly off. But I've never used a valet key before so leave it home
I also bought Stauber and are using them. They are stronger than the Lexus type , but I will give them a try
Just what we needed for our 1999 RX300 Lexus
The product arrived on time. The locksmith replaced the old broken FOB shell with the new replacement shell. The FOB functions as intended in the new shell. We have the second shell case available if we need it.
Easy change over from my worn remote tool about 1 ...
Quick shipment. Easy change over from my worn remote tool about 1 minute. Worked first time and every time since. Great quick fix. Used old back plate to retain Toyota logo
Bought this for my 2013 Ford Flex. Perfect fit and finish. This item did not have the little Ford logo on the back, but with all the money you save by doing it yourself who cares?
... my old one into this one and it works fine! Great way to renew your FOB without paying ...
Swapped out parts from my old one into this one and it works fine but the range seems to be much shorter now. Cannot remote start from as far away now. But it's a great way to renew your FOB without paying dealer price.
Just like Ford OEM
Arrived quickly - looks exactly like a Ford OEM key fob. Was very easy to change out the internals / chip. Would purchase again in the future if needed
$14. not $250. No Brainer
Saved a couple hundred bucks for sure, from what a Toyota dealer would want to do to me. Works perfectly. Amazon is the best, as usual.
Easy to take apart
100% Legit... Easy to take apart. Transferred all the parts as before, put it back together and BOOM! it worked like magic. Biggest concern was when you slide the back part off DO NOT FORCE IT you will break the sliding alignments. Also your car will not start if you do not forget to include the little black magnet from the old case. P.S. when buying this product make sure that you also buy a new 3v battery. New case. Ew battery works well together.
buttons no longer worked on old fob. Simply replaced shell with this one, and buttons worked again.
As good as the original in my opinion. Along with the case and blank key, also included were 5 screws (which is one extra), a Duracell CR2032 battery, and a new RFID chip which I did not use. I transferred the motherboard and RFID chip from the old key fob to the new one and it works perfectly.